banner

banner

|

Wednesday, December 14, 2016

Getting Phoenix Rooter Plumbing To Clear Those Blocks

Phoenix Rooter Plumbing
Phoenix Rooter Plumbing
Phoenix rooter plumbing has a proud history. Rooter plumbing began back around WWI. Prior to its use when a block occurred in a pipe, it was a game of guessing where the block was and then digging up the pipe to check and then replace or clear the block. This process was a little destructive and invasive, so there was a bit of a push to find a better way to clear the drains.

Phoenix Rooter Plumbing
Phoenix Rooter Plumbing
It was decided that you could use a length of steel cable with some blades on the end and spin it, which takes out almost any block that occurs. A very common block was tree roots, so the blades and spinning had to be strong enough to cut through and clear the roots. Originally the rooters were hand powered, but eventually made it to both gas and electrical power.

There are still smaller hand-powered devices for Phoenix rooter plumbing today, but they are mostly used in smaller or more delicate situations. Commonly a hand-powered rooter is used when a block has occurred in a toilet. The cable can snake its way through the tubes of the toilet and then helps break up whatever is stopping the water.

Phoenix Rooter Plumbing
Phoenix Rooter Plumbing
Phoenix rooter plumbing is an important part of today's plumbing tool kit. It's an effective way to clear most blocks and is used well by almost every plumbing professional. It is something that can be feasibly done on your own, but it takes some skill and knowledge not to cause more damage to pipes, especially if you are using a motorized version. Electrical and gas motors attached to blades can cause severe damage, even in copper pipes, if they aren't used right, so it is important to always be careful in whatever you try with Phoenix rooter plumbing.

No comments:

Post a Comment